StillSmart

Brew belt. Not much use?

2011-03-31T17:01:01+00:00

The belts arent the best I have discovered, they lost alot of heat, they burn out, trip the fuses, and get hot spots deforming the fermenters .....
leason learnt I now use the 25W heating panels with polystyrene between the floor and the pad. It heats from the bottom at an even temp, creating convection currents (remember that experiment you had to do in year 7 with boiling tea leaves?). It had a 3 year warranty and i have had it for 7 years, not sure if you have access to them but they are a new zealand brand. looks a little out dated in art work but its good at what it does, heating panel from my local HBS
if you do get a belt, make sure its a good quality one, I use to put mine 1/3 up the fermenter.

Statistics: Posted by freelancement — Thu Mar 31, 2011 5:01 pm

Brew belt. Not much use?

2011-03-31T16:46:44+00:00

Hey lejomr

(perhaps easy to do as an Austrailan (?)) I\'ve used a 30w heat pad for about 5 years with beer(though \'our winter\' in Subtropical Aus isnt the same of course) where supplied yeasts like 20-25 degrees C and its ALWAYS been of benefit. My father-in-law uses a belt and he\'s often complaining (similar \'outside\' temps involved). So....if its not going to be a 300w fishtank heater perhaps a 30w pad AND a fermenter wrapped in the same stuff you would use for a camping mattress underlay (wrapped immediately after the wash has \'max temped\') will do?? Of couse your fermenter needs a micro-climate too.

Statistics: Posted by Frank — Thu Mar 31, 2011 4:46 pm

Brew belt. Not much use?

2010-12-12T00:30:32+00:00

Thanks Sharmead. Might give that a go! Cheers.

Statistics: Posted by lejomr — Sun Dec 12, 2010 12:30 am

Brew belt. Not much use?

2010-12-09T22:05:58+00:00

I use the method I\'ve used for Home brew for years. The fermenter is standing in a plastic dustbin filled with water to the level of the Mash. Temperature of water in bin is maintained at 20 with a 300watt Fish Tank Heater. This has coped with the current cold spell & I\'ve never had any problems in summer either.

Statistics: Posted by sharmead — Thu Dec 09, 2010 10:05 pm

Brew belt. Not much use?

2010-12-06T01:28:27+00:00

I use a heat mat which seems to work with no problems have had it for 3 years

Statistics: Posted by hic52 — Mon Dec 06, 2010 1:28 am

Brew belt. Not much use?

2010-12-05T23:55:26+00:00

Thanks Phantom. I will check the sg tomorrow night but it appears the ferment has stopped after only 5 days. Makes me wonder if it has stuck or even died.

Statistics: Posted by lejomr — Sun Dec 05, 2010 11:55 pm

Brew belt. Not much use?

2010-12-05T21:35:33+00:00

I don\'t use mine often, but it gets to a similar set of numbers, never had any problem with it though..... The ferments always finished Ok....

Statistics: Posted by Phantom — Sun Dec 05, 2010 9:35 pm

Brew belt. Not much use?

2010-12-05T15:38:02+00:00

Has anyone had success with one of these?
I can\'t regulate the temperature with it. The belt is now at the very top of the wash (25 litre mark) but the wash is at least 26c; not surprisingly fermentation has stopped. I have turned it off wind hope that fermentation will start again.
However so far I\'d have to say the belt isn\'t much use. Should I consider anyway mat instead?
Any ideas?

Statistics: Posted by lejomr — Sun Dec 05, 2010 3:38 pm