StillSmart

Re: Water leakage

2014-01-30T15:59:43+00:00

Wrapping the probe with PTFE tape and then twisting it back in should tighten it up so that it doesn't leak.

Statistics: Posted by vino-tinto — Thu Jan 30, 2014 3:59 pm

Re: Water leakage

2014-01-30T15:31:25+00:00

Many thanks, I cannot get my temp down any lower than 63 degrees as the water shoots out if I turn if up any more, any ideas, someone suggested blue tac but I'm unsure about this

Statistics: Posted by wingwong — Thu Jan 30, 2014 3:31 pm

Re: Water leakage

2014-01-30T13:09:37+00:00

Wrap the probe with some PTFE tape

Statistics: Posted by vino-tinto — Thu Jan 30, 2014 1:09 pm

Re: Water leakage

2014-01-30T12:39:57+00:00

I find that if my water pressure is too high it will leak around the temp probe just use a little less water.

Statistics: Posted by Spudnik1954 — Thu Jan 30, 2014 12:39 pm

Water leakage

2014-01-30T10:33:46+00:00

Hi, has anyone had any problems with water leakage from the thermometer probe housing???

Statistics: Posted by wingwong — Thu Jan 30, 2014 10:33 am