To make the test a little easier to monitor (just alcohol and water) I used some weak spirits rather than raw mash for this test.
The \"feedstock\" I gave it was diluted down to 30% with distilled water - I am not able to get a good \"after reading\" as the salt of course makes a difference to the hydrometer reading - however I can confirm that after being salt-dried, if you pour it into a spoon you can light it easily.
One interesting aspect is that salt apepars (work of others not me) to have more of an afinity to methanol than ethanol - so albeit only present in miniscule (if any) amounts with most home brews, if there WAS a small amount, the salt certainly wouldn\'t have an advere effect.
The good news is that it has had me searching for something better and I think Sodium Sulphate might be the answer. Harmless (unless breathed as a dust or dumped in the eyes) at which point is nasty in the same way as you wouldn\'t put salt in your eyes. Sodium sulphate though is apparently TOTALLY insoluble in ethanol however - as opposed to salt which is SLIGHTLY soluble.
Once again the sodium sulphate can be re-used once dried.
Short of setting up a very large drying tower with perhaps the best part of 25-100Kg of salt / sodium sulphate, I am not convinced it is a practical way of taking mash to the bottle without a still. I do think they might be able to compliment each other well though.
Although I will repeat my experiment when I get hold of the sodium sulphate, I think this method of drying may have its place if you want very high purity ethanol from a pot still by the following steps (which again I will test when I get the sodium sulphate)
Pass 1 > 60% - 65%
Pass 2 > 75% - 80%
Pass 3 > 85%
>> drying with salt to make much stronger in ethanol content but alas salty
Pass 4 to leave salt behind in the still and give the highest possible output.
I am also going to do a small sample of mash with a high salt load simply to see if it doesn\'t hinder alcohol boiling off but retards the watercoming off - as salt water boils at a higher temperature. Not sure if there is merit in the logic or not, but will risk 5 litres of mash half way through the next run of 5 > 6 to see what efect it has on yield, strength and flavour.
Sorry I do not have more accurate figures yet - or more promising results with the salt, but at least the sodium sulphate looks like it might help - especially if followed by a distillation process too.
Will keep you posted when I know more but it might take a week or so for the sulphate to arrive.
MarkStatistics: Posted by guymark — Fri May 27, 2011 5:44 am
]]>