StillSmart

Re: Glue

2018-01-10T03:32:06+00:00

HA6 is a superb sealant/adhesive/gasketing material.
Allow it a minimum 24 hours to dry/cure.
And all should be good.

Robert.

Statistics: Posted by Easydrinker — Wed Jan 10, 2018 3:32 am

Re: Glue

2018-01-09T17:43:17+00:00

Ive tried it with the T500 on and i think it will be ok.
Thanks for the all the replies- i will keep you updated with first mash

Statistics: Posted by Spirit — Tue Jan 09, 2018 5:43 pm

Re: Glue

2018-01-09T19:27:45+00:00

You beat me too it Myles. I will just add - those bowls are VERY thin be careful it will support the weight you are putting on it? (and they are a pig to weld)

Statistics: Posted by Mash — Tue Jan 09, 2018 5:11 pm

Re: Glue

2018-01-09T16:40:26+00:00

https://www.amazon.co.uk/Bond-Transparent-Adhesive-Premium-Silicone/dp/B00BBIARNA/ref=sr_1_1?ie=UTF8&qid=1515515850&sr=8-1&keywords=bond-it+ha6

Marine aquarium sealant. Don`t use normal silicone sealant.

Statistics: Posted by Myles — Tue Jan 09, 2018 4:40 pm

Re: Glue

2018-01-09T15:46:03+00:00

https://www.ebay.co.uk/itm/Stainless-St ... 2749.l2649

This is the one , i purchased the 28cms one, i drilled ,cut a 58mm (i think) hole in the bottom for the T500 to fit too and this fits perfect on my boiler without the seal. The only problem is that if i fit the seal to the lid it catches the lifting handles on the boiler but if the seal was a bit shorter it would allow it to fit on top of the boiler not the new lid. This would make it a much better job.

Statistics: Posted by Spirit — Tue Jan 09, 2018 3:46 pm

Re: Glue

2018-01-09T15:10:40+00:00

I haven’t got an answer for your question but interested that you’ve found a bowl the right size for the T500? Where from? I want one too

Welcome aboard btw

Statistics: Posted by H12rpo — Tue Jan 09, 2018 3:10 pm

Glue

2018-01-09T14:35:53+00:00

This is my first post so go easy with me.
I have an Ace micro brewery boiler for which i need a seal for around the top for the new lid to fit too, i have a silicone pressure cooker seal but it is a bit too large on the outer diameter. My plan is to cut it and remove about 10-15mm and rejoin the seal with adhesive or glue. Having read about the nasties in different things could anyone recommend a glue or adhesive to me.

The set up so far is as follows
T500
New lid made from a stainless steel bowl with hole cut for T500

I,m hoping to start the first ferment later this week

Statistics: Posted by Spirit — Tue Jan 09, 2018 2:35 pm