StillSmart

Re: to stop copper mesh from touching the slant plates

2014-11-09T07:40:04+00:00

I had some copper wire from a twin & earth cable and just soldered it across in a mesh patern where I wanted the scrubber to come to, if you don't have something like that, cut some thin rings from a spare bit of pipe, open them up and solder them in.

Statistics: Posted by vino-tinto — Sun Nov 09, 2014 7:40 am

Re: to stop copper mesh from touching the slant plates

2014-11-07T22:07:19+00:00

When I made my first boka, I didnt use anything, I was using ceramic Raschig rings as packing so I filled it upside down leaving a gap of a few inches, then turned it the right way up and give it a good shake to ensure there was a good gap, another time I pushed an SS scrubber up to the plates then filled with Raschig rings, today I have cut te column in half and fitted a 54mm joint, I don't use the raschig rings anymore, just fill the column with SS scrubbers then fit the boka top and seal it.

Statistics: Posted by Anavrin — Fri Nov 07, 2014 10:07 pm

to stop copper mesh from touching the slant plates

2014-11-07T18:33:02+00:00

guys before I start making the slots for the slant plates been
pondering about summat. is it worth drilling a couple of holes
just beneath the bottom slant plates or slots then either use
copper wire or a strip of copper to stop the copper mesh touching
the bottom slant plate or leave it

Statistics: Posted by Magnu420 — Fri Nov 07, 2014 6:33 pm