StillSmart

stripping runs

2010-06-10T01:57:21+00:00

You take it down to 5%abv??doesnt seem worth it.Most people have said to around 20%abv is enough,but well each to their own i guess.I just followed some simple guidelines and works a treat.

Some of the commercial distillers will go down to 1%, apparently.
In my case it started out as laziness, and it\'s become habit.......

Statistics: Posted by Phantom — Thu Jun 10, 2010 1:57 am

stripping runs

2010-06-09T20:53:51+00:00

On a stripping run I usually carry on until the ABV coming off is about the same as it was in the initial wash, using the pot still calculator as a guide. Amounts to about a third of the total volume. I have no particular reason for this, just seems about right.

Statistics: Posted by phlogiston — Wed Jun 09, 2010 8:53 pm

stripping runs

2010-06-09T16:17:26+00:00

You take it down to 5%abv??doesnt seem worth it.Most people have said to around 20%abv is enough,but well each to their own i guess.I just followed some simple guidelines and works a treat.

Statistics: Posted by marc83 — Wed Jun 09, 2010 4:17 pm

stripping runs

2010-06-09T02:02:14+00:00

Done my first two strip runs yesterday,very quick.Both time including 1 hr warm up took just 2hrs.Thats two 25L washes.

I had detuned my essencia still to run like a pot still.Started cooling water flow through the condenser only at 60 degrees,tossed first 50ml(some dont bother on strip runs)then collected everything all the way down to 30%ABV,where the temp finished at 92 degrees,i averaged 1L every 15minutes.

Will see tonight if i have enough for a spirit run after a bit more dilution,otherwise will put another wash on.

All I do with my 25L SS reflux is to take the reflux column collar out of the loop (change pipe config) and make sure that there's only a couple of rashig rings in the bottom of the reflux chamber, that way the condenser doesn't get overwhelmed and just run the water to the condenser.
I then collect to about 95 degree's C - the distillate is usually down to less than 5% ABV by then, takes about 4 hours or so to do a full batch.......

Statistics: Posted by Phantom — Wed Jun 09, 2010 2:02 am

stripping runs

2010-06-08T00:30:14+00:00

Done my first two strip runs yesterday,very quick.Both time including 1 hr warm up took just 2hrs.Thats two 25L washes.

I had detuned my essencia still to run like a pot still.Started cooling water flow through the condenser only at 60 degrees,tossed first 50ml(some dont bother on strip runs)then collected everything all the way down to 30%ABV,where the temp finished at 92 degrees,i averaged 1L every 15minutes.

Will see tonight if i have enough for a spirit run after a bit more dilution,otherwise will put another wash on.

so far so good

Statistics: Posted by marc83 — Tue Jun 08, 2010 12:30 am