TURBO 500 can I make Gin?
Hi, is it possible to make Gin in the Turbo 500 without adding bottled flavorings , is it possible to add botanicals to produce gin flavors in the finished spirit.
Thank you.
Thank you.
Diverch wrote:You will need to build a pot head for the t500.
The t500 is a reflux still and will strip all the taste out of anything, making a neutral, this can then be run through a pot head with botanicals and make gin.
A pot head can be made for about £50. That's actually my job for tomorrow
Diverch

Capt-Cudellez wrote:Will reflux strip some flavour? Yes but it will be far far away from being neutral. It could make a really nice gin. London Dry gin has to be taken off at above 90% and can be run on something like a 4 plate still to maintain the ABV.
I always recommend making gin with neutral in the boiler, no need to do a vapour infused gin, you can macerate the spirit for 12-24 hours then just run it without any additional investment or build on your part.
When I had a T500 it would normally output in the 93-94% range, so either run a bit faster than a neutral run (forget about temps, just time the output rate), or remove an inch or so of packing to make it less efficient.
One problem with the ceramics saddles is they will be a bugger to clean, so you might risk making the next thing you run on it tasting a little like gin - this is where having separate gear will really pay off.
Try it you might like it, if you don't, try something else
There is much to be said for owning job specific tools though.
If you have the wallet and the space, it can save you lots of time.
Sadly this equation is only usually learned from experience.
Mash wrote:There is much to be said for owning job specific tools though.
If you have the wallet and the space, it can save you lots of time.
Sadly this equation is only usually learned from experience.
Too true. I was only thinking the same Sunday when I pressed my wine - I have quite a ponsey OTT press but without it I doubt I would still be making.