Page 2 of 2
Re: Where to find this reducer?

Posted:
Tue Jan 19, 2016 10:36 pm
by Easydrinker
Mash wrote:Will the Very Silly Still be air-cooled?
The intention is to try for a forced air cooled reflux column...
A step up from Riko's spiral still.
Hence the name.
It will fill my trilogy of stills- Smart Still,Silly Still,&________
Robert.
Re: Where to find this reducer?

Posted:
Wed Jan 20, 2016 7:26 am
by Mash
Morning Robert
Sounds good. You know I like the whole air cooled idea.
Re: Where to find this reducer?

Posted:
Thu Jan 21, 2016 2:54 pm
by Benoit
I apologise now for the link I posted, seems they switched at some point & are much smaller. I bought 3 sets, 1 is like the ones I bought previously but the other 2 are small round the neck, if anyone gets stuck then this is how I have had to get them to hold


Benoit
Re: Where to find this reducer?

Posted:
Thu Jan 21, 2016 8:37 pm
by Blue_Duck
Would be a lot easier if we could get our hands on them
2"copper ferrules, that's why i posted the link earlier
in the thread. Iv'e tried sourcing them but all roads
lead to the good old US of A. they work out at approx.
£25.00 with post.I was going to need three for an idea
that was kicking around in my head.
The plan was to make my collumn modular with the bulkhead
fitting from s/d, and with some spare 54ml pipe make a 4"
gin basket then it all could be tri-clamped together.
I know the s/s ferrules are hell of a lot cheaper but i
lack the confidence soldering/braizing or welding s/s to
copper. My soldering skills are moderate at the least,
i'm not a proper welder (pun intended)
cheers B_D
Re: Where to find this reducer?

Posted:
Thu Jan 21, 2016 9:28 pm
by Benoit
The 2" are currently out of stock on the Still Dragon Europe site, €16 for the part then another few quid postage. When they're back in stock of course! Get some map gas & give brazing a go, it's easier than you think
Benoit
Re: Where to find this reducer?

Posted:
Thu Jan 21, 2016 9:51 pm
by Blue_Duck
To be honest Benoit, i don't think they will get back in
stock.(just a feeling i get) copper to copper isn't a big
deal for me, i managed vino's pothead build and a liebig
with reasonable success, but s/s to copper i'm not very
comfortable with. Iv'e heard if not done properly the
join could crack or split under the intense heat when you
run the boiler. not something i want to take a chance on.
cheers B_D
Re: Where to find this reducer?

Posted:
Thu Jan 21, 2016 10:54 pm
by Easydrinker
I have only brazed in extremis,but have discovered that I can do it.
This hobby pushes me out of my comfort zone on occasion, but cheers me when I discover that Shit that once scared me is nothing to be afraid of.
You are here a short time and a long time gone.
Mess with life,it will mess with you.
Robert.
Re: Where to find this reducer?

Posted:
Fri Jan 22, 2016 6:46 am
by Sunshine
Hi all!
Our 2" copper ferrules are already on the ship to us. We will have them back in stock by end of February.
Best regards,
Judith