Refilling the Essencia Ceramic Filter
Hi Guys
After hearing that Easydrinker once managed to re-fill his Essencia Ceramic Filter after the bottom of it came loose, I decided to have a go at mine, it's not designed to come apart, so if you try this and F#%k yours up, it's your own fault!
Firstly I pushed a normal dinner knife down between the side of the ceramic dome and the plastic lip around the bottom edge to ensure there was no sealant around the sides, then gently pushing down a little harder at various places to see if I could break the seal around the bottom of the ceramic dome and the plastic bottom.
I managed to get the bottom off

You can see the sealant around the edge of the bottom plastic cover, I managed to remove this by prizing it off with the same knife as before, I also noticed the filter only about 2/3 full of quite course carbon.
Here's a pic of it once all clean

I couldn't get the normal 900gr bag of carbon I normally buy from my HBS so I had to settle for an overpriced bag of StillSpirits Z carbon, £4.60 for 205gr

There wasn't quite enough to fill both filters in the bag so I filled the ceramic one 2/3 full before applying some food grade silicone rubber around the bottom edge of the ceramic dome to stick the plastic bottom back on.

The rest of the carbon filled the carbon filter about to about 75-80% full.
I'm going to give it 24hrs for the silicone to set then test it out, I also give the ceramic dome a good scrub with a sponge scourer to clean the outside of it.
After hearing that Easydrinker once managed to re-fill his Essencia Ceramic Filter after the bottom of it came loose, I decided to have a go at mine, it's not designed to come apart, so if you try this and F#%k yours up, it's your own fault!
Firstly I pushed a normal dinner knife down between the side of the ceramic dome and the plastic lip around the bottom edge to ensure there was no sealant around the sides, then gently pushing down a little harder at various places to see if I could break the seal around the bottom of the ceramic dome and the plastic bottom.
I managed to get the bottom off

You can see the sealant around the edge of the bottom plastic cover, I managed to remove this by prizing it off with the same knife as before, I also noticed the filter only about 2/3 full of quite course carbon.
Here's a pic of it once all clean

I couldn't get the normal 900gr bag of carbon I normally buy from my HBS so I had to settle for an overpriced bag of StillSpirits Z carbon, £4.60 for 205gr

There wasn't quite enough to fill both filters in the bag so I filled the ceramic one 2/3 full before applying some food grade silicone rubber around the bottom edge of the ceramic dome to stick the plastic bottom back on.

The rest of the carbon filled the carbon filter about to about 75-80% full.
I'm going to give it 24hrs for the silicone to set then test it out, I also give the ceramic dome a good scrub with a sponge scourer to clean the outside of it.
