StillSmart

i wanted to add some extra copper mesh so here goes. whats the verdict would this work ok
?i rolled some copper mesh and added it inside the cooling coil then put the copper saddles back in and then added the ceramic saddles back too. OK ? or should i remove it ?
Thanks
Jag

I did the same thing , I packed some copper mesh around the coil in the top of the column and then put the ceramics back in. It helped with temp stabilization a lot and also prevents ceramics and copper bits from plugging the out put.

i haven't had time to run this new adaptation yet i have a wash clearing with Sparkolloid of which i am amazed at how clear its getting. Anyway i will post the results of what i think hopefully it will be fine
Thanks
Jag