Racking off?

Discuss fermentation, different types of wash, etc

Racking off?

Postby hic52 » Tue Nov 30, 2010 3:57 pm

I normally rack off after using a clearing solution when the crud is settled usually about 24/36 hours, but noticed this morning while putting in the solution (never normally read instructions lol) that it says on the pack to rack off before adding the solution - what does everyone else do?
User avatar
hic52
Regular
Regular
 
Posts: 79
Joined: Wed Nov 10, 2010 9:39 pm

Racking off?

Postby wld trky » Wed Dec 01, 2010 9:18 am

I didn\'t on the first wash, but have since and it is clearer. I could see the bottom of the container
User avatar
wld trky
Newcomer
 
Posts: 8
Joined: Tue Nov 23, 2010 8:38 am
Location: australia

Racking off?

Postby umpa » Sat Dec 04, 2010 8:16 pm

I make the wash, then add some cheepo finings from wilco\'s. I never bother about the wash being totally clear - its not worth the hassle.
User avatar
umpa
Experienced Distiller
Experienced Distiller
 
Posts: 211
Joined: Fri Dec 19, 2008 1:33 pm
Location: Planet Earth

Racking off?

Postby marc83 » Sun Dec 05, 2010 2:25 pm

I got into the habit of racking off then adding the finings,now its just the norms for me,a bit clearer than how i used to do it.
User avatar
marc83
Experienced Distiller
Experienced Distiller
 
Posts: 218
Joined: Sat Apr 17, 2010 1:29 pm
Location: New Zealand

Racking off?

Postby hic52 » Sun Dec 05, 2010 3:38 pm

Thanks all have some wash just started so will try that way when its finished
User avatar
hic52
Regular
Regular
 
Posts: 79
Joined: Wed Nov 10, 2010 9:39 pm

Racking off?

Postby Andy » Sun Dec 05, 2010 3:52 pm

I dont rack off, I am just careful when emptying into 5 litre jugs to put in the still.

I will run about 200ml into a jug to remove the sediment thats in the tap then collect the rest 5 litres at a time to put into the still.

Works for me.
User avatar
Andy
Senior Distiller
Senior Distiller
 
Posts: 331
Joined: Tue Dec 01, 2009 6:21 am
Location: QLD

Racking off?

Postby wld trky » Thu Dec 09, 2010 12:24 pm

If you place a wooden spoon under the container where the tap is all the sediment will angle back away from the tap due to the angle of the container.
User avatar
wld trky
Newcomer
 
Posts: 8
Joined: Tue Nov 23, 2010 8:38 am
Location: australia

Racking off?

Postby Andy » Thu Dec 09, 2010 4:57 pm

Doing that would limit the amount you could collect.

I leave it flat and am able to drain as much as possible.
User avatar
Andy
Senior Distiller
Senior Distiller
 
Posts: 331
Joined: Tue Dec 01, 2009 6:21 am
Location: QLD

Racking off?

Postby hic52 » Fri Dec 10, 2010 12:02 am

My container hasn\'t a tap so will have to use a plastic pipe to syphon
User avatar
hic52
Regular
Regular
 
Posts: 79
Joined: Wed Nov 10, 2010 9:39 pm

Racking off?

Postby Andy » Fri Dec 10, 2010 2:55 am

Do yourself a favor and install a tap, its so much easier.
User avatar
Andy
Senior Distiller
Senior Distiller
 
Posts: 331
Joined: Tue Dec 01, 2009 6:21 am
Location: QLD

Racking off?

Postby short2 » Fri Dec 10, 2010 3:18 am

I racked off this morning and ran the still for the second time got got 3.5 litres all but a ml. Cut it and got 7.5 litre. and bottled it. I dont have a test tube to measure the percentage, so do it in the bucket but dont know if it is accurate enough doing it that way. AT 7.5 It was registering 40%. Will need to get a testube soon as. Did not put it through the Z filter as it does my head in.Tried it and find it leaks like a sieve no matter how tight you make it. The Carbon is messy and I cant wash it through without getting shit everywhere. Will make my Christmass an Essencia or the EZ. Cheers guys all tip welcome.
User avatar
short2
Experienced Distiller
Experienced Distiller
 
Posts: 106
Joined: Tue Oct 19, 2010 11:27 pm
Location: Scotland

Racking off?

Postby wld trky » Fri Dec 10, 2010 3:47 am

The idea of placing the spoon under is to keep the sediment away from the tap. Once you are draining it off you remove the spoon to get it back flat and drain. Works for me
User avatar
wld trky
Newcomer
 
Posts: 8
Joined: Tue Nov 23, 2010 8:38 am
Location: australia


Return to Fermentation

Who is online

Users browsing this forum: No registered users and 0 guests

User Menu

Login Form

Who is online

In total there are 0 users online :: 0 registered, 0 hidden and 0 guests (based on users active over the past 5 minutes)
Most users ever online was 72 on Mon Oct 15, 2018 1:14 pm

Users browsing this forum: No registered users and 0 guests