Racking off?
12 posts
• Page 1 of 1
Racking off?
I normally rack off after using a clearing solution when the crud is settled usually about 24/36 hours, but noticed this morning while putting in the solution (never normally read instructions lol) that it says on the pack to rack off before adding the solution - what does everyone else do?
-

hic52 - Regular

- Posts: 79
- Joined: Wed Nov 10, 2010 9:39 pm
Racking off?
I didn\'t on the first wash, but have since and it is clearer. I could see the bottom of the container
-

wld trky - Newcomer
- Posts: 8
- Joined: Tue Nov 23, 2010 8:38 am
- Location: australia
Racking off?
I make the wash, then add some cheepo finings from wilco\'s. I never bother about the wash being totally clear - its not worth the hassle.
-

umpa - Experienced Distiller

- Posts: 211
- Joined: Fri Dec 19, 2008 1:33 pm
- Location: Planet Earth
Racking off?
I got into the habit of racking off then adding the finings,now its just the norms for me,a bit clearer than how i used to do it.
-

marc83 - Experienced Distiller

- Posts: 218
- Joined: Sat Apr 17, 2010 1:29 pm
- Location: New Zealand
Racking off?
Thanks all have some wash just started so will try that way when its finished
-

hic52 - Regular

- Posts: 79
- Joined: Wed Nov 10, 2010 9:39 pm
Racking off?
I dont rack off, I am just careful when emptying into 5 litre jugs to put in the still.
I will run about 200ml into a jug to remove the sediment thats in the tap then collect the rest 5 litres at a time to put into the still.
Works for me.
I will run about 200ml into a jug to remove the sediment thats in the tap then collect the rest 5 litres at a time to put into the still.
Works for me.
-

Andy - Senior Distiller

- Posts: 331
- Joined: Tue Dec 01, 2009 6:21 am
- Location: QLD
Racking off?
If you place a wooden spoon under the container where the tap is all the sediment will angle back away from the tap due to the angle of the container.
-

wld trky - Newcomer
- Posts: 8
- Joined: Tue Nov 23, 2010 8:38 am
- Location: australia
Racking off?
Doing that would limit the amount you could collect.
I leave it flat and am able to drain as much as possible.
I leave it flat and am able to drain as much as possible.
-

Andy - Senior Distiller

- Posts: 331
- Joined: Tue Dec 01, 2009 6:21 am
- Location: QLD
Racking off?
My container hasn\'t a tap so will have to use a plastic pipe to syphon
-

hic52 - Regular

- Posts: 79
- Joined: Wed Nov 10, 2010 9:39 pm
Racking off?
Do yourself a favor and install a tap, its so much easier.
-

Andy - Senior Distiller

- Posts: 331
- Joined: Tue Dec 01, 2009 6:21 am
- Location: QLD
Racking off?
I racked off this morning and ran the still for the second time got got 3.5 litres all but a ml. Cut it and got 7.5 litre. and bottled it. I dont have a test tube to measure the percentage, so do it in the bucket but dont know if it is accurate enough doing it that way. AT 7.5 It was registering 40%. Will need to get a testube soon as. Did not put it through the Z filter as it does my head in.Tried it and find it leaks like a sieve no matter how tight you make it. The Carbon is messy and I cant wash it through without getting shit everywhere. Will make my Christmass an Essencia or the EZ. Cheers guys all tip welcome.
-

short2 - Experienced Distiller

- Posts: 106
- Joined: Tue Oct 19, 2010 11:27 pm
- Location: Scotland
Racking off?
The idea of placing the spoon under is to keep the sediment away from the tap. Once you are draining it off you remove the spoon to get it back flat and drain. Works for me
-

wld trky - Newcomer
- Posts: 8
- Joined: Tue Nov 23, 2010 8:38 am
- Location: australia
12 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 0 guests